renamed tk*.h in file contents, and deleted unused files

1 files changed, 0 insertions, 64 deletions

diff --git a/arch/adc-calibration.h b/arch/adc-calibration.h
deleted file mode 100644
index f0b05ab..0000000
--- a/arch/adc-calibration.h
+++ /dev/null
@@ -1,64 +0,0 @@
-// tk-calibration.h: Attiny calibration header.
-// Copyright (C) 2015-2023 Selene ToyKeeper
-// SPDX-License-Identifier: GPL-3.0-or-later
-#pragma once
-
-// This allows using a single set of hardcoded values across multiple projects.
-
-/********************** Voltage ADC calibration **************************/
-// These values were measured using RMM's FET+7135.
-// See battcheck/readings.txt for reference values.
-// the ADC values we expect for specific voltages
-#define ADC_44     194
-#define ADC_43     189
-#define ADC_42     184
-#define ADC_41     178
-#define ADC_40     173
-#define ADC_39     168
-#define ADC_38     163
-#define ADC_37     158
-#define ADC_36     152
-#define ADC_35     147
-#define ADC_34     142
-#define ADC_33     137
-#define ADC_32     131
-#define ADC_31     126
-#define ADC_30     121
-#define ADC_29     116
-#define ADC_28     111
-#define ADC_27     105
-#define ADC_26     100
-#define ADC_25     95
-#define ADC_24     90
-#define ADC_23     84
-#define ADC_22     79
-#define ADC_21     74
-#define ADC_20     69
-
-#define ADC_100p   ADC_42  // the ADC value for 100% full (resting)
-#define ADC_75p    ADC_40  // the ADC value for 75% full (resting)
-#define ADC_50p    ADC_38  // the ADC value for 50% full (resting)
-#define ADC_25p    ADC_35  // the ADC value for 25% full (resting)
-#define ADC_0p     ADC_30  // the ADC value for 0% full (resting)
-#define ADC_LOW    ADC_30  // When do we start ramping down
-#define ADC_CRIT   ADC_27  // When do we shut the light off
-
-
-/********************** Offtime capacitor calibration ********************/
-// Values are between 1 and 255, and can be measured with offtime-cap.c
-// See battcheck/otc-readings.txt for reference values.
-// These #defines are the edge boundaries, not the center of the target.
-#ifdef OFFTIM3
-// The OTC value 0.5s after being disconnected from power
-// (anything higher than this is a "short press")
-#define CAP_SHORT           190
-// The OTC value 1.5s after being disconnected from power
-// Between CAP_MED and CAP_SHORT is a "medium press"
-#define CAP_MED             94
-// Below CAP_MED is a long press
-#else
-// The OTC value 1.0s after being disconnected from power
-// Anything higher than this is a short press, lower is a long press
-#define CAP_SHORT           115
-#endif
-