diff options
Diffstat (limited to 'hwdef-BLF_LT1.h')
| -rw-r--r-- | hwdef-BLF_LT1.h | 58 |
1 files changed, 0 insertions, 58 deletions
diff --git a/hwdef-BLF_LT1.h b/hwdef-BLF_LT1.h deleted file mode 100644 index 4e81c42..0000000 --- a/hwdef-BLF_LT1.h +++ /dev/null @@ -1,58 +0,0 @@ -#ifndef HWDEF_BLF_LT1_H -#define HWDEF_BLF_LT1_H - -/* BLF LT1 driver layout - * ---- - * Reset -|1 8|- VCC - * eswitch -|2 7|- (unused) - * aux LED -|3 6|- PWM (5000K) - * GND -|4 5|- PWM (3000K) - * ---- - */ - -#define ATTINY 85 -#include <avr/io.h> - -#define PWM_CHANNELS 1 // 1 virtual channel (1 for main LEDs + 1 for 2nd LEDs) -#define PWM_BITS 9 // 0 to 255 at 15.6 kHz, but goes to 510 for "200%" turbo -#define PWM_TOP 255 - -// dynamic PWM with tint ramping (not supported on attiny85) -//#define USE_DYN_PWM // dynamic frequency and speed -//#define PWM1_CNT TCNT0 // for dynamic PWM, reset phase -//#define PWM1_PHASE_RESET_OFF // force reset while shutting off -//#define PWM1_PHASE_RESET_ON // force reset while turning on -//#define PWM1_PHASE_SYNC // manual sync while changing level - -// usually PWM1_LVL would be a hardware register, but we need to abstract -// it out to a soft brightness value, in order to handle tint ramping -// (this allows smooth thermal regulation to work, and makes things -// otherwise simpler and easier) -uint16_t PWM1_LVL; - -#define PWM1_PIN PB0 // pin 5, warm tint PWM -#define TINT1_LVL OCR0A // OCR0A is the output compare register for PB0 - -#define PWM2_PIN PB1 // pin 6, cold tint PWM -#define TINT2_LVL OCR0B // OCR0B is the output compare register for PB1 - - -#define AUXLED_PIN PB4 // pin 3 - -#define SWITCH_PIN PB3 // pin 2 -#define SWITCH_PCINT PCINT3 // pin 2 pin change interrupt - -#define ADC_PRSCL 0x07 // clk/128 - -// average drop across diode on this hardware -#ifndef VOLTAGE_FUDGE_FACTOR -#define VOLTAGE_FUDGE_FACTOR 7 // add 0.35V -#endif - -#define FAST 0xA3 // fast PWM both channels -#define PHASE 0xA1 // phase-correct PWM both channels - -#define LAYOUT_DEFINED - - -#endif |