diff options
Diffstat (limited to '')
| -rw-r--r-- | spaghetti-monster/anduril/anduril-manual.txt | 39 |
1 files changed, 34 insertions, 5 deletions
diff --git a/spaghetti-monster/anduril/anduril-manual.txt b/spaghetti-monster/anduril/anduril-manual.txt index 96640f6..3f17f41 100644 --- a/spaghetti-monster/anduril/anduril-manual.txt +++ b/spaghetti-monster/anduril/anduril-manual.txt @@ -56,6 +56,13 @@ While the light is on, a few basic actions are available: - Click, hold: Change brightness (down). - 3 clicks: Switch to the other ramp. - 4 clicks: Go to ramp config mode. + - 5 clicks: Activate manual memory and save the current brightness. + - 5 clicks, but hold the last click: Go back to automatic memory. + +The "automatic" vs "manual" memory modes change the level the light goes +to with 1 click from off. In automatic mode, it uses the last +brightness the user ramped to. In manual mode, it uses the brightness +the user explicitly saved with 5 clicks. Other Modes @@ -215,7 +222,10 @@ then return to the regular "off" mode. Lockout mode also doubles as a momentary moon mode, so the user can do quick tasks without having to unlock the light. The brightness in -lockout mode is determined by the floor setting of the current ramp. +lockout mode has two levels: + + - Hold: light up at the floor level of the current ramp. + - Click, Hold: light up at the floor level of the other ramp. Momentary Mode @@ -223,11 +233,23 @@ Momentary Mode Click 5 times from Off to enter Momentary mode. This locks the flashlight into a single-mode interface where the LEDs are only on when -the button is held down. It is intended for Morse code and other -signalling tasks. +the button is held down. It is intended for Morse code, light painting, +and other tasks where the light should be on only for a short time and +probably in a pattern. + +Momentary mode does either a steady brightness level or a strobe. To +select which one, go to the mode you want to use, adjust the brightness +and speed and other settings, then turn the light off. Then click 5 +times to enter momentary mode. + +Supported momentary modes are steady (normal ramping mode) and strobes +(everything in the "strobe" mode group). -Brightness is the last-ramped level, so adjust that before entering -momentary mode. +In steady mode, brightness is the last-ramped level, so adjust that +before entering momentary mode. + +In momentary strobe mode, the settings are copied from the last-used +strobe mode, such as party strobe, tactical strobe, or lightning. To exit this mode, physically disconnect power by unscrewing the tailcap or battery tube. @@ -352,6 +374,13 @@ click the button a few times: This should change the aux LEDs to the next mode supported on this light. +If the aux LEDs can change color, there are additional actions to change +the color. It is the same as above, but hold the button on the last +click and then let go when the desired color is reached. + + - Off mode: 7 clicks, but hold the last click. + - Lockout mode: 3 clicks, but hold the last click. + For lights with a button LED, the button LED typically stays on while the main emitters are on. Its brightness level is set in a way which mirrors the main LED -- off, low, or high. |