diff options
Diffstat (limited to 'spaghetti-monster')
| -rw-r--r-- | spaghetti-monster/anduril/cfg-fw3x-lume1.h | 28 |
1 files changed, 9 insertions, 19 deletions
diff --git a/spaghetti-monster/anduril/cfg-fw3x-lume1.h b/spaghetti-monster/anduril/cfg-fw3x-lume1.h index 0ab93ca..cf4d9bc 100644 --- a/spaghetti-monster/anduril/cfg-fw3x-lume1.h +++ b/spaghetti-monster/anduril/cfg-fw3x-lume1.h @@ -44,18 +44,17 @@ // TODO: test if underclocking works on lume1 //#define HALFSPEED_LEVEL 14 //#define QUARTERSPEED_LEVEL 5 - -// the entire ramp is regulated except turbo; don't blink halfway up -#ifdef BLINK_AT_RAMP_MIDDLE -#undef BLINK_AT_RAMP_MIDDLE -#endif - // don't slow down at low levels; this isn't that sort of light // (it needs to stay at full speed for the 10-bit PWM to work) #ifdef USE_DYNAMIC_UNDERCLOCKING #undef USE_DYNAMIC_UNDERCLOCKING #endif +// the entire ramp is regulated except turbo; don't blink halfway up +#ifdef BLINK_AT_RAMP_MIDDLE +#undef BLINK_AT_RAMP_MIDDLE +#endif + #define RAMP_SMOOTH_FLOOR 1 #define RAMP_SMOOTH_CEIL 149 // turn on BuckBoost from level 1 to 149, but not 150 @@ -72,6 +71,9 @@ #define MUGGLE_FLOOR RAMP_DISCRETE_FLOOR #define MUGGLE_CEILING 99 +// slow down party strobe; this driver can't pulse for too short a time +#define PARTY_STROBE_ONTIME 4 + // optional, makes initial turbo step-down faster so first peak isn't as hot // FET mode can run very very hot, so be extra careful //#define THERM_HARD_TURBO_DROP @@ -79,22 +81,10 @@ // stop panicking at ~85% regulated power or ~750 lm #define THERM_FASTER_LEVEL 140 -// respond to thermal changes faster -#define THERMAL_WARNING_SECONDS 3 -#define THERMAL_UPDATE_SPEED 1 -#define THERM_PREDICTION_STRENGTH 4 -//#define THERM_RESPONSE_MAGNITUDE 128 +#define THERM_CAL_OFFSET 0 // not needed due to external sensor // easier access to thermal config mode, similar to Emisar, Noctigon #define USE_TENCLICK_THERMAL_CONFIG -// slow down party strobe; this driver can't pulse for too short a time -#define PARTY_STROBE_ONTIME 4 - -#ifdef THERM_CAL_OFFSET -#undef THERM_CAL_OFFSET -#endif -#define THERM_CAL_OFFSET 0 // not needed due to external sensor - // can't reset the normal way because power is connected before the button #define USE_SOFT_FACTORY_RESET |