// Mateminco MT35-Mini / Astrolux FT03
// Copyright (C) 2022-2023 (original author TBD), Selene ToyKeeper
// SPDX-License-Identifier: GPL-3.0-or-later
#pragma once

/*
 *           ----
 *   Reset -|1  8|- VCC
 * eswitch -|2  7|- Aux LED
 *  1x7135 -|3  6|- NC
 *     GND -|4  5|- FET
 *           ----
 */

#define HWDEF_C  hank/emisar-d4/hwdef.c

// channel modes
// * 0. FET+7135 stacked
#define NUM_CHANNEL_MODES  1
enum CHANNEL_MODES {
    CM_MAIN = 0,
};

#define DEFAULT_CHANNEL_MODE  CM_MAIN

// right-most bit first, modes are in fedcba9876543210 order
#define CHANNEL_MODES_ENABLED 0b00000001


#define PWM_CHANNELS 2  // old, remove this

#define PWM_BITS      8       // attiny85 only supports up to 8 bits
#define PWM_GET       PWM_GET8
#define PWM_DATATYPE  uint8_t
#define PWM_DATATYPE2 uint16_t
#define PWM1_DATATYPE uint8_t   // little FET ramp
#define PWM2_DATATYPE uint8_t   // big FET ramp

#define PWM_TOP_INIT  255    // highest value used in top half of ramp

// 1x7135 channel
#define CH1_PIN  PB4        // pin 3, 1x7135 PWM
#define CH1_PWM  OCR1B      // OCR1B is the output compare register for PB4

// DD FET channel
#define CH2_PIN  PB0        // pin 5, FET PWM
#define CH2_PWM  OCR0A      // OCR0A is the output compare register for PB0

// lighted button
#define AUXLED_PIN   PB2    // pin 7

// e-switch
#ifndef SWITCH_PIN
#define SWITCH_PIN   PB3    // pin 2
#define SWITCH_PCINT PCINT3 // pin 2 pin change interrupt
#endif

#define ADC_PRSCL   0x07    // clk/128

// average drop across diode on this hardware
#ifndef VOLTAGE_FUDGE_FACTOR
#define VOLTAGE_FUDGE_FACTOR 7  // add 0.35V
#endif

#define FAST 0xA3           // fast PWM both channels
#define PHASE 0xA1          // phase-correct PWM both channels


inline void hwdef_setup() {
    // configure PWM channels
    DDRB = (1 << CH1_PIN)
         | (1 << CH2_PIN);

    // configure PWM channels
    TCCR0B = 0x01; // pre-scaler for timer (1 => 1, 2 => 8, 3 => 64...)
    TCCR0A = PHASE;

    // Second PWM counter is ... weird
    TCCR1 = _BV (CS10);
    GTCCR = _BV (COM1B1) | _BV (PWM1B);
    OCR1C = PWM_TOP_INIT;  // Set ceiling value to maximum

    // configure e-switch
    PORTB = (1 << SWITCH_PIN);  // e-switch is the only input
    PCMSK = (1 << SWITCH_PIN);  // pin change interrupt uses this pin
}


#define LAYOUT_DEFINED