Merge branch 'trunk' into emisar-d3aa

* trunk:
  enabled eeprom read/write stabilization by default on recent MCUs, to prevent corrupt data
  thefreeman-avr32dd20-devkit: enable boost bypass at boot, so AA/NiMH can boot
  avr32dd20-devkit: use unimplemented "CH" pin as a boost bypass control
  added "emisar-2ch-fet-joined" build, for D4S w/ lighted switch
  documented FW3X swapped pins better
  documented Wurkkos TS25/TS11/FC13 distinctions
  build.sh: don't require DFPs, newer avr-libc doesn't need them
  use BLIP_LEVEL instead of 0 for "blip"s
  clarified which-hex-file.md a bit; make sure the model number matches
  fw3x: reduced pulsing on low modes

1 files changed, 8 insertions, 6 deletions

diff --git a/bin/build.sh b/bin/build.sh
index d044ca5..ed0a837 100755
--- a/bin/build.sh
+++ b/bin/build.sh
@@ -37,12 +37,14 @@ else
   echo "Unrecognized MCU type: '$MCUNAME'"
   exit 1
 fi
-# ensure the DFP files exist
-if [ ! -d "$DFPPATH" ]; then
-  echo "Atmel DFP files not found: '$DFPPATH'"
-  echo "Install DFP files with './make dfp'"
-  exit 1
-fi
+# skip verification because newer avr-libc doesn't need DFPs,
+# so the DFP shouldn't be mandatory
+## ensure the DFP files exist
+#if [ ! -d "$DFPPATH" ]; then
+#  echo "Atmel DFP files not found: '$DFPPATH'"
+#  echo "Install DFP files with './make dfp'"
+#  exit 1
+#fi
 
 export CC=avr-gcc
 export CPP=avr-cpp