diff options
Diffstat (limited to 'hw/lumintop/fw3x-lume1/anduril.h')
| -rw-r--r-- | hw/lumintop/fw3x-lume1/anduril.h | 27 |
1 files changed, 20 insertions, 7 deletions
diff --git a/hw/lumintop/fw3x-lume1/anduril.h b/hw/lumintop/fw3x-lume1/anduril.h index b208fbc..5cde5e9 100644 --- a/hw/lumintop/fw3x-lume1/anduril.h +++ b/hw/lumintop/fw3x-lume1/anduril.h @@ -11,7 +11,7 @@ * - 85: https://ww1.microchip.com/downloads/en/DeviceDoc/Atmel-2586-AVR-8-bit-Microcontroller-ATtiny25-ATtiny45-ATtiny85_Datasheet.pdf */ -#include "lumintop/fw3x-lume1/hwdef.h" +#define HWDEF_H lumintop/fw3x-lume1/hwdef.h // set this light for 50C thermal ceiling #undef DEFAULT_THERM_CEIL @@ -46,11 +46,6 @@ #undef USE_DYNAMIC_UNDERCLOCKING #endif -// the entire ramp is regulated except turbo; don't blink halfway up -#ifdef BLINK_AT_RAMP_MIDDLE -#undef BLINK_AT_RAMP_MIDDLE -#endif - #define RAMP_SMOOTH_FLOOR 1 #define RAMP_SMOOTH_CEIL 149 // turn on BuckBoost from level 1 to 149, but not 150 @@ -59,21 +54,39 @@ #define LED_ENABLE_PIN_LEVEL_MAX 149 // 10 33 56 79 102 125 [149] #define RAMP_DISCRETE_FLOOR 10 -#define RAMP_DISCRETE_CEIL RAMP_SMOOTH_CEIL +#define RAMP_DISCRETE_CEIL RAMP_SMOOTH_CEIL #define RAMP_DISCRETE_STEPS 7 #define SIMPLE_UI_FLOOR RAMP_DISCRETE_FLOOR #define SIMPLE_UI_CEIL 120 #define SIMPLE_UI_STEPS 5 +// show each channel while it scroll by in the menu +#define USE_CONFIG_COLORS + +// blink numbers on the main LEDs by default (but allow user to change it) +#define DEFAULT_BLINK_CHANNEL CM_MAIN + // slow down party strobe; this driver can't pulse for too short a time #define PARTY_STROBE_ONTIME 4 +// use aux red + aux blue for police strobe +#define USE_POLICE_COLOR_STROBE_MODE +#define POLICE_STROBE_USES_AUX +#define POLICE_COLOR_STROBE_CH1 CM_AUXRED +#define POLICE_COLOR_STROBE_CH2 CM_AUXBLU + // stop panicking at ~85% regulated power or ~750 lm #define THERM_FASTER_LEVEL 140 #define THERM_CAL_OFFSET 0 // not needed due to external sensor +// don't blink while ramping +#ifdef BLINK_AT_RAMP_MIDDLE +#undef BLINK_AT_RAMP_MIDDLE +#endif + + // can't reset the normal way because power is connected before the button #define USE_SOFT_FACTORY_RESET |