diff options
Diffstat (limited to 'hwdef-Sofirn_SP10-Pro.h')
| -rw-r--r-- | hwdef-Sofirn_SP10-Pro.h | 24 |
1 files changed, 22 insertions, 2 deletions
diff --git a/hwdef-Sofirn_SP10-Pro.h b/hwdef-Sofirn_SP10-Pro.h index bb10f2f..d7c2081 100644 --- a/hwdef-Sofirn_SP10-Pro.h +++ b/hwdef-Sofirn_SP10-Pro.h @@ -49,13 +49,17 @@ PA1 : Boost Enable // PWM parameters of both channels are tied together because they share a counter #define PWM1_TOP TCA0.SINGLE.PERBUF // holds the TOP value for for variable-resolution PWM // not necessary when double-buffered "BUF" registers are used -//#define PWM1_CNT TCA0.SINGLE.CNT // for resetting phase after each TOP adjustment +#define PWM1_CNT TCA0.SINGLE.CNT // for resetting phase after each TOP adjustment +#define PWM1_PHASE_RESET_OFF // force reset while shutting off +#define PWM1_PHASE_RESET_ON // force reset while turning on +//#define PWM1_PHASE_SYNC // manual sync while changing level #define LED_ENABLE_PIN PIN1_bp #define LED_ENABLE_PORT PORTA_OUT +//#define LED_OFF_DELAY 4 // only needed when PWM1_PHASE_RESET_OFF not used #define USE_VOLTAGE_DIVIDER // use a dedicated pin, not VCC, because VCC input is flattened -#define DUAL_VOLTAGE_FLOOR 20 // for AA/14500 boost drivers, don't indicate low voltage if below this level +#define DUAL_VOLTAGE_FLOOR 21 // for AA/14500 boost drivers, don't indicate low voltage if below this level #define DUAL_VOLTAGE_LOW_LOW 7 // the lower voltage range's danger zone 0.7 volts (NiMH) #define ADMUX_VOLTAGE_DIVIDER ADC_MUXPOS_AIN9_gc // which ADC channel to read @@ -121,4 +125,20 @@ inline void hwdef_setup() { } +// set fuses, these carry over to the ELF file +// we need this for enabling BOD in Active Mode from the factory. +// settings can be verified / dumped from the ELF file using this +// command: avr-objdump -d -S -j .fuse anduril.elf +FUSES = { + .WDTCFG = FUSE_WDTCFG_DEFAULT, // Watchdog Configuration + .BODCFG = FUSE_ACTIVE0_bm, // BOD Configuration + .OSCCFG = FUSE_OSCCFG_DEFAULT, // Oscillator Configuration + .TCD0CFG = FUSE_TCD0CFG_DEFAULT, // TCD0 Configuration + .SYSCFG0 = FUSE_SYSCFG0_DEFAULT, // System Configuration 0 + .SYSCFG1 = FUSE_SYSCFG1_DEFAULT, // System Configuration 1 + .APPEND = FUSE_APPEND_DEFAULT, // Application Code Section End + .BOOTEND = FUSE_BOOTEND_DEFAULT, // Boot Section End +}; + + #endif |